Special Applications
Clean Rooms
RAYFLEX SECTOR SOLUTIONS
Controlled and quick pass for clean rooms.
Pressure balance in clean room passages, particle control and surface hygiene are basic design criteria. Rayflex systems are projected in accordance with controlled area protocols and facility automation.
Control of thermal insulation, sealing and energy losses
In the choice of insulated industrial door, panel or curtain structure, as well as environmental seals, guide zones, threshold detail and the opening time of the door should be examined. It will remain open for a long time than the requirement of a door with high insulation value, it can improve the contact of the conditional area with the external environment. Therefore, in applications such as cold storage, food production area, climated warehouse or heated production section, the speed is evaluated in the same performance account.
Temperature difference, humidity, pressure and daily use of the door should be shared with the technical team prior to offer. The insulation is quick PVC doors can often create a strong thermal limit in the lower cycle openings of insulated sectional panels while helping reduce contact time in the transition. The structure details around the door do not be alone if the best panel is not appropriate. The preparation of the mounting surface and the regular control of the seals contribute to the protection of the energy performance throughout the use.
Security sensors and user protection systems
Security in automatic industrial doors is not a single photocell. Only the risk profile of a controlled pass, which is used by the model of the door, the direction of movement, pedestrian and vehicle traffic, the approach speed and the condition of vision, can be selected together with equipment such as photocell, light curtain, safety edge, radar, warning lamp or audio warning. With a shipping area with forklift traffic, the risk profile of a controlled pass is not the same. The detection area of sensors should be tested with real traffic during the commissioning.
Energy failure, sensor failure, emergency and manual opening scenarios should be defined in project stage. The gate is subject to unexpected obstacle or backward movement, type and control logic of security hardware. The basic training to users should not be left under the door and not be closed of the front of the sensors. The functions of safety equipment in periodic care should be recorded only by testing and not.
Integration of automation, access control and plant systems
An industrial automatic door can be activated by radar, remote control, push button, pull cord, magnetic loop, access card or licence-plate recognition. The appropriate trigger is selected according to traffic direction and access-control requirements. A radar set too wide can cause unnecessary openings, while late detection leaves vehicles waiting in front of the door. Sensor parameters should therefore be adjusted on site after observing approach points, vehicle dimensions and user behaviour.
Door control panel in advanced facilities PLC The production line can exchange signals with building management system, fire alarm or warehouse management. The door can be transferred to the open, closed or faulty status information center system; the cycle meter can provide data to maintenance planning. Interlock between two volumes, air lock or opening fiction can be applied in order. If the introduction, exit and security logic of the integration is defined in the quotation stage, the panel, wiring and the scope of the software is prepared correctly.
Industrial door selection according to the sector
It is important to clean surfaces, fast closing, contactless trigger and limit air movement between regions. Temperature difference, condensation and open stay time are evaluated in cold weather applications. High cycle, forklift safety and production line integration in automotive and general production is outstanding. The wide range of vehicles in logistics centres should be considered to be a relationship with intensive shipping hours and ramp equipment of the door.
Welding areas may require special conditions for chemical plants or corrosive environments in terms of material and electrical equipment. The major opening in airports, shipyards and hangars is wind load and carrier system decisive. In supermarket, service, parking and commercial buildings, quiet operation, appearance, access control and user comfort can gain more importance. The final model, as two plants in the same industry can be different, should be selected not only by looking at the industry name, but according to the actual use scenario on the field.