Commercial Applications
Auto Washing Facilities
RAYFLEX SECTOR SOLUTIONS
Controlled and fast switching for Auto Washing Facilities.
In auto washing entries, moisture, water and frequent opening cycles are forced door components. Rayflex quick doors are applied with corrosion resistant structure, wide viewing area and automatic trigger options.
Angle speed, cycle number and operation efficiency
The opening speed of the door is an important parameter, especially affecting the waiting time in busy traffic lines, but the highest speed is not the most accurate choice for each project. The gate size should be discussed together with the speed of the upcoming vehicle, the viewing distance, sensor detection area and the safe closing scenario. realistic determination of the daily cycle number allows the motor to choose the movement transmission elements and the appropriate capacity of the control unit. A system that is not designed for intensive use can often run early abrasion and unplanned downtimes.
Operation efficiency is not measured only in seconds. The tool of the radar detects at the right distance, the door does not open to unnecessary location and the closing with proper delay after vehicle passing, determines the total cycle time. Interlock application between two controlled areas affects the flow of doors with each other. Thanks to the correct automation scenario, high speed, security and energy control turn into a system that supports each other.
Rüzgâr strength and evaluation of supporting structure
Outdoor industrial doors can be exposed to continuous wind pressure as well as sudden wind shocks. The total force of the effect on the door surface increases when openness grows, so curtain or panel, guides, side bumps, upper mechanism and connection points should be projected according to the same load scenario. The wind resistance indicated in the catalog can be connected to the model, measurement and application condition. The highest value should not be assumed to be if it is applicable for all sizes.
The reinforced concrete, steel or prefabricated surface of the door is also part of the system. The bearing construction must be safely transferred the door loads and the effects of the movement. Building corners, mutual clearances, high facades and wind-open zones may require special evaluation. The appropriate anchor is also important to periodic connection control until the correct assembly range and controlled commissioning. Thus, the protection of the intended strength in the design stage is supported during the operation period.
Security sensors and user protection systems
Security in automatic industrial doors is not a single photocell. Only the risk profile of a controlled pass, which is used by the model of the door, the direction of movement, pedestrian and vehicle traffic, the approach speed and the condition of vision, can be selected together with equipment such as photocell, light curtain, safety edge, radar, warning lamp or audio warning. With a shipping area with forklift traffic, the risk profile of a controlled pass is not the same. The detection area of sensors should be tested with real traffic during the commissioning.
Energy failure, sensor failure, emergency and manual opening scenarios should be defined in project stage. The gate is subject to unexpected obstacle or backward movement, type and control logic of security hardware. The basic training to users should not be left under the door and not be closed of the front of the sensors. The functions of safety equipment in periodic care should be recorded only by testing and not.
Maintenance, service and cost of total ownership
Industrial door price shows the initial investment cost; but more meaningful assessment for the enterprise is the cost of total ownership. Energy consumption, planned maintenance, infused parts, service response time and production loss that the door can create due to failure should be considered together. A small irregularity in a high door can turn bigger wear in a short time. Periodic control, suitable for the manufacturer plan, helps reduce unexpected postures.
During maintenance, guides, connections, motor, motion transmission elements, panel or curtain, seals, control panel and all safety sensors should be examined. The pulse of the door can change the working conditions of equipment placement after the ground distortion or sensor field. The regular retention of service records makes the problems that repeat. Access to spare parts, the technical team's reputation and the intervention plan is part of the decision of purchasing the investment is increasing.